Re: PHC shanks

Posted by: Tom
Email:
Date Posted: April 18, 2008
Subject: Re: PHC shanks

The fit of mouthpieces is an interesting subject - in my experience all products vary a bit one from the other, including horn mouthpieces. It does seem to be important that the mouthpiece goes into the pipe 'the right amount', and the Lawsons have a theory about it, but exactly what that amount is is not clear.

It is impossible (ok, very difficult) to measure how long the tapered part of the mouthpipe is and if one's objective is to get the small end of the mouthpiece sitting as exactly as possible where that taper ends and the mouthpipe venturi is, that measurement would be needed. If you give your mouthpiece to your mouthpipe maker then he/she could make the receiver taper to suit it - i.e. to bring the tip of the mouthpiece to the 'right' point. Otherwise there will always be a bit of guesswork involved, and given others' comments about phc/ alex fits this whole business probably doesn't matter as much as nerds like me seem to make it...

Tom

Follow Ups:

• Re: Re: PHC shanks Curious 19/4/2008 (2)
  • Re: Re: Re: PHC shanks PHC 19/4/2008 (1)
    • Re: Re: Re: Re: PHC shanks Tom 19/4/2008 (0)